Datenschutz | AGB | Impressum
and also the power supply should be unavailable
11:09 on 5.11.2019
How does the crank type power press machine work? Some people are curious about this problem, because the crank sort power pres machine can be used in many aspects with our lives, has made various contributions to people's lives, and has become an essential assistant in human development and life. There are also the various models of crank type power touch machine, like C shape single crank press, C frame double crank touch, H frame single crank media, etc. This article will detail the details on the work of the crank variety power press.

This article contains these aspects:
Working principle
Harmless operation

1、Working theory
The output power and motion in the motor are transmitted into the intermediate transmission shaft through the belt drive, and then transmitted on the crankshaft through the gear transmission, and the slider can be driven to move down and up linearly. The rotational motion with the crankshaft becomes a reciprocating motion of the slider through the registering rod. The upper mold is fixed within the slider, and the lower mold is fixed about the table pad. Crank type power touch can pressurize the material placed between top of the and lower molds, as well as workpiece is made suitable workpiece by the mold to appreciate pressure processing.

2、Safe operations
With any machine, you ought to understand that only the ideal operation can make the equipment work best and employ a longer life. So first you have to know how to produce the press work.

1) While installing the mold, the closing height with the mold must be adapted into the closing height of the particular press. The inching stroke needs to be used when adjusting the closing height in the press. The workbench from the press is not allowed to become at the lowest restrict position, but should be for the middle limit of their adjustment amount, and the mold has to be fixed firmly.

2) Carefully check the pressure with the compressed air before job. When the pressure is less than 3. 92 MPa, the press shouldn't be started. Check the equipment's operating system in addition to lubrication system are standard. Check that the handbags, brakes and guards are generally safe and in excellent condition.

3) To reduce the slider of crank form power press from acquiring stuck, it is strictly prohibited to overload the job.

4) After the continuous motor is started, the slider need to be operated for forging following on from the flywheel speed is typical. During operation, the operator must not leave the post it is not allowed to clean, adjust and lubricate the gear. Do not allow your current hand or tool to realize the slider stroke variety.

5) A safety cover really should be installed on the pedal control panel to forestall the slider from suddenly falling on account of accidental pressure from others or other objects, resulting in an accident.

6) When the press is working continuously for an extended time, it should pay attention to measure whether there is any phenomenon such as overheating, smoking, sparking, and so forth. in the motor, clutch i465 black, brake, slider and information rail. If it can be, it should be cooled properly before continuing to figureout.

7) At the end of the work, the slider should be lowered to the bottom dead center position, and also the power supply should be unavailable, the compressed air should be turned off, the work site need to be arranged, and the handover work should be completed.

The detailed answer in this paper is that the crank type power press machine works this way; how to make the compressor work along with the precautions when the compressor succeeds, these three problems. Have you any idea all kinds of information regarding crank type power touch machine work from quite a few angles?
Kommentare (0)
RSS Feed aller Mitglieder KV GmbH